电缆槽模具生产现场必须与水、电、气和易燃易爆、有毒的物品打交道，为了防止在工作过程中发生失火、爆炸、中毒利人身、设备以及质量事故的发生，要注意安全生产。
The production site of cable trough mould must deal with water, electricity, gas and inflammable, explosive and toxic substances. In order to prevent fire, explosion, poisoning and personal, equipment and quality accidents in the process of work, attention should be paid to safety production.

防爆：现场使用的乙炔、氧气等均为易燃易爆气体，稍有不慎，就会发生文火和爆炸，因此对于易燃易爆的气液体的使用必须严格按照操作规程执行。对于潮湿的工具和零件未经干燥的情况下，放入加热炉，水蒸气的膨胀，都会产生爆炸或喷小灼伤人员，因此只要是需要入炉的任何器具和零件必须进行干燥。
Explosion proof: acetylene, oxygen, etc. used on site are flammable and explosive gases. Slight carelessness may lead to slow fire and explosion. Therefore, the use of flammable and explosive gas and liquid must be carried out in strict accordance with the operating procedures. When wet tools and parts are put into the heating furnace without drying, the expansion of water vapor will cause explosion or small spray burns. Therefore, any apparatus and parts that need to be put into the furnace must be dried.

防毒：热处理所使用的一些热处理介质均有较强的毒件，再加之前高温之下产生的有毒气体和生产中产生的废水，都对人体产生极大的危害。因此操作者必须注意穿戴好防护服和防毒面具，生产现场必须保持遇风利抽风，下班后必须注意清洗和清洁工作
Anti poison: some heat treatment media used in heat treatment have strong toxic parts. In addition, toxic gases produced under high temperature before and waste water produced in production will cause great harm to human body. Therefore, the operator must pay attention to wear protective clothing and gas mask. The production site must keep ventilation in case of wind, and pay attention to cleaning and cleaning after work

防火：必须经常检合生产现场的电线是否老化、破损和短路，检查油槽内油液是否溢出、泊温是否安全、沟盖板冷却循环系统是否工作可靠，检查现场的大火器材是否完备和正常工作。
Fire prevention: it is necessary to regularly check whether the wires on the production site are aged, damaged and short circuited, whether the oil in the oil tank overflows, whether the mooring temperature is safe, whether the cooling circulation system of the trench cover plate works reliably, and whether the fire equipment on site is complete and normal.

以上是电缆槽模具生产安全注意事项。
The above is the cable trough mold production safety precautions.